Digital Thermal Sensor Module Temperature Sensor Module for Arduino

Features:

• using the NTC thermistor sensor , good sensitivity

• the comparator output signal clean waveform is good , driving ability, than 15mA.

• adjust the temperature distribution bit detection threshold

• Working voltage 3.3V-5V

• the output format : Digital switching output (0 and 1)

• with bolt holes for easy installation

• a small board PCB size : 3.2cm x 1.4cm

• using a wide voltage LM393 comparator

Usage:

• the thermal resistance of the module is very sensitive to the ambient temperature , generally used to detect the ambient temperature ;

• through the adjustment of the potentiometer , can change the temperature detection threshold (ie, temperature control value) , if necessary to control the ambient temperature is 50 degrees , the module in the corresponding ambient temperature to which the green light , DO output is HIGH level falls below the set temperature value, the output is high , the green light does not shine ;

• DO output can be directly connected with the microcontroller through the microcontroller to detect high and low , thereby detecting the ambient temperature changes ;

• DO OUR outputs can directly drive the relay module , which can be composed of a thermostat to control the operating temperature of related equipment can also be connected to the fan used to heat and other ;

• the detection range of the module's temperature 20-80 °C ;

• this module can also be replaced with a wire temperature sensor for water temperature, water tank controlled.